Cutting a section off also would ruin any heat treatment and they would just bend. Most leaf spring packs are WAY too much poundage to draw by hand, and even individual spring leaves are too thick and wide. If I were to make a crossbow.bow, I would probably make it from some 1/4" thick by 1" wide, tapered slightly to 3/16ths thick at the ends.īest advice I think would be to go to like a gander mountain or sporting goods store that carries crossbows and look at and possibly take measurements of they're bows. I don't know of any charts that show certain dimensions VS poundage. Make a Dragon or Tiger Chu ko nu from scratch Use these plans to cut, drill and glue simple wood pieces into a wooden mechanical artwork. It could possibly work but would not be the best without reworking spring section so heavily you may as well start with barstock. The Flying Hun - Chu Ko Nu (Chinese Repeating Crossbow II) The second Chinese repeater from Mike Loades personal collection. How to Take a Repeating Crossbow: This instructable will how you select to make a repeating crossbow, furthermore called a " Zhuge nu" or " chu ko nu." Aforementioned is a type of catapult created in China thousands of years ahead such is like somebody ancient submachine gun. No offense, but you say you have "enough woodworking and metalworking experience to make it all" coupled with asking if a leaf spring would work hits right off you don't have enough metalworking experience.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |